Home | Register | Login | Contact Us

 
Auto Math
Classifieds
Forum
Gallery
Games
Garage
Tech Articles
Utilites
 
FAQFAQ    SearchSearch    RegisterRegister    Log inLog in    Log in to check your private messagesLog in to check your private messages    Forum Subscriptions1/4 Mile Table 

AF sensor for individual cylinders

 
Post new topic   Reply to topic    SMOKEmUP.com Forum Index -> Tools
View previous topic :: View next topic  
Author Message
UTgcEP
Newbie


Joined: 11 Jun 2008
Posts: 8

359.02 points



PostPosted: Thu Jun 19, 2008 1:46 pm    Post subject: AF sensor for individual cylinders Reply with quote

I am looking for an air/fuel sensor that can monitor the air/fuel rate for each cylinder. I was told that such a device exists but can't seem to find it on the web. Does any one know where I could find one of these Question

thanks
Back to top
View user's profile Send private message AIM Address
squeeezer
Member


Joined: 02 Mar 2007
Posts: 2427
Location: new richmond WI
191524.76 points


1991 Chevrolet Camaro

PostPosted: Thu Jun 19, 2008 2:52 pm    Post subject: Reply with quote

anyone who sells engine dynomometers
dont know how you would set it up in car though


id say wide band o2 ftw

_________________
Back to top
View user's profile Send private message
clay
Moderator


Joined: 24 Nov 2002
Posts: 3209
Location: South Carolina
318129.23 points


1972 Chevrolet Nova

PostPosted: Fri Jun 20, 2008 4:32 am    Post subject: Reply with quote

Innovate does make a setup that can support an O2 for every cylinder. Not cheap though. Here is a link. Clay
http://www.innovatemotorsports.com/products/st12.php

_________________
I have done so much with so little for so long, I can now do anything with nothing.
Back to top
View user's profile Send private message
SMOKEmUP
PostMaster


Joined: 30 May 2002
Posts: 3169

65097.54 points


1979 Chevrolet Camaro

PostPosted: Fri Jun 20, 2008 9:34 am    Post subject: Reply with quote

All eight cylinders? That's going to put a dent in your wallet. Why not just put bungs on each cylinder capping off the ones you're not using and move the sensor around to find the rich and lean cylinders then tune from there?
_________________
Stop running from your pain and embrace your pain. Your pain is going to be a part of your prize.

I challenge you to push yourself.
Back to top
View user's profile Send private message Visit poster's website
UTgcEP
Newbie


Joined: 11 Jun 2008
Posts: 8

359.02 points



PostPosted: Fri Jun 20, 2008 11:39 am    Post subject: Reply with quote

Thanks Clay, yeah that is a bit out of my price range, but pretty cool. I didn't think about capping of the cylinders, would that screw with the vehicles O2 sensor since less fuel is being consumed ?
Back to top
View user's profile Send private message AIM Address
SMOKEmUP
PostMaster


Joined: 30 May 2002
Posts: 3169

65097.54 points


1979 Chevrolet Camaro

PostPosted: Fri Jun 20, 2008 12:18 pm    Post subject: Reply with quote

So long as the cap doesn't leak then it should be the same.
_________________
Stop running from your pain and embrace your pain. Your pain is going to be a part of your prize.

I challenge you to push yourself.
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    SMOKEmUP.com Forum Index -> Tools All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum
Home | Contact Us | Automath | Cam Files | Dyno Search | Forum | Garage | Picture Gallery | Reaction Timer

Copyright 1997-2016 SMOKEmUP.com All rights reserved.
Advertising Info     Disclaimer     Privacy Policy